Carefully Turn The Key In A Clockwise Direction.

Rotate the key in the keyhole to adjust the height of the flame as needed. To ignite the pilot light, press your finger into the center of the control knob and hold it in place. That is a gas log set installed in a wood burning fireplace.

This Allows The Thermocouple To Warm Up And Ensures The Flame Stays Lit.

Turn the control knob to a pilot position. Skytech wireless wall mounted on off gas fireplace switch. You could put a thermocouple interrupter block between the current valve and thermocouple, then add short leads (less that 3') with a switch.

Insert The Wall Key Inside The Keyhole.

Do gas fireplaces need electricity? That gas log valve was not designed to have a switch, but you could change the valve and pilot to one that does take a switch/remote. Turn off the control knob for about 5 minutes.

Turn The Key Counterclockwise To Start The Flow Of Gas And Light The Pilot.

It requires an electric source to create a spark that ignites the pilot light. Take the neutral line and connect it to the n input. To ignite the pilot light, press your finger into the center of the control knob and hold it in place.

Now Your Remote Control Is Ready To Function.

Reset the knob to the pilot position: Redo the flat screws and. The fire should remain on, and you can adjust the flames.